Check engine light after Motordyne ISO install
Check engine light after Motordyne ISO install
Hey all. I recently installed the 5/16" spacer and the Throttle Body mods, did the battery disconnect, throttle body learning position update AND the overnight battery disconnect and I'm stil getting the check engine light. I also installed a new set of NGK's Iridiums too, but I don't think this would cause the light.
Any suggestions? Or should I just head to the Nissan dealer and see if they can reset the TB as well.
Any suggestions? Or should I just head to the Nissan dealer and see if they can reset the TB as well.
Former G35driver Vendor
iTrader: (23)
Joined: Jul 2004
Posts: 3,054
Likes: 85
From: Los Angeles California
That usually happens if the battery was reconnected before all the maf and TB plugs are put back in.
EDIT: It can also happen if one of the TB harness wires is lose in the TB plug. I've seen it happen before.
EDIT: It can also happen if one of the TB harness wires is lose in the TB plug. I've seen it happen before.
Last edited by Hydrazine; Jun 29, 2009 at 01:16 AM.
I got a P0444 Evaporative Emission Control System Purge Control Valve Circuit Open fault.
I tried to get Nissan to take a look, but they said NO. The Infiniti dealer is about an hour away.
Suggestions? I have the pubs and I'm going through them now.
I tried to get Nissan to take a look, but they said NO. The Infiniti dealer is about an hour away.
Suggestions? I have the pubs and I'm going through them now.
Thread
Thread Starter
Forum
Replies
Last Post




