Curious to see what people think. The skunk2 is fairly new ( I think ) and I don't think it has been talked about much. From what I could find, mostly newbies talk or prefer this one and the alumni prefer the Motordyne. Should be interesting. I hope someone tries a comparison.

Which Plenum Spacer do you prefer? Make case?
Skunk2
Motordyne
AAM
http://www.mmrusa.com/s2plen.htm
http://www.motordyneengineering.com/g35.asp

I did not include Crawford because I wanted to do a poll on just spacers.

 

crawford

 

lol

 

i duno about skunk 2 but i would not go with AAM.. the quality of the spacer does not match with motordynes.. also it re-uses some of the bolts while motordyne gives you a new set of bolts + washers. AAM also left out two of the bolts (where the two hex bolts are) in their package

 

Can't beat Motordyne.
2 main reasons..
- iso-thermal isolates entire plenum
- center posts seal & support

 

Who says you can't mix the Skunk2 with the iso thermal spacer and coppert throttle bottle heater from Motordyne.

 

has anyone actually tried the skunk2 spacer yet?

 

+1 Crawford

Lou

 

I would not even mess with Skunk2. I've seen and held the actual spacer in my hands. I've also seen a few pictures of burnt up plenums from them being used.

Stick with what is proven for our cars.....Motordyne (or Crawford if you want a complete upper plenum replacement).