Ok I read through all the chatter on previous threads about fitting Z exhausts on G coupes but haven't come to a final conclusion. Is it safe to say it could be done with the 6" spacer and perhaps a little customization from the muffler shop with regards to the hanger placement?

Thank you,
Chris

 

Is there a difference between the G200 exhaust for the 350z and G35 coupe...i found a place where i can get it but its for the 350z. will i need anything else besides the 8in extension for the exhaust?

 

i have no idea

-chris

 

If you get an extension piece, that will bring the muffler to about the correct position. However, with most (if not all) Z exhausts, the tips will be too short for the G. Likewise, a G35c exhaust will have tips that are too long for the Z, and they'll stick way out past the bumper.

 

Is there a difference in the exhausts? I have an almost brand new 350Z catback exhaust that I was going to try to sell. I might try to install it if there is a better difference.

 

I sold a Stillen cat-back system to a G35 pilot just
a few months ago. I kept in touch just to make sure
the install went as I had told him. All that was needed was the 6" extension. He also mentiond that
the system sounds "Sweet"! Oh yea, a muffler dude
that knows his $hit helps....... Cost should be
in the $100 range, not much more. You shouldn't
have to make any other changes....like tips.

 

dont buy the extension pipe

just go to a muffler shop and they will add the correct amount of piping to make it fit just right.......and they install on for you......i got it done for $100 because the car is a g35.........it really should be about $70

im in houston by the way so it maybe a little bit cheaper here but it shouldnt be over $140

 

ok i'll be ordering my exhaust soon. anyone have any GReddy Trust connections?

thanx for the help,
chris

 

i did that with my Tanabe exhaust. which is stil for sale DAMMIT! i had an 8 inch extension added on it and it fit pretty well. its the angled tip so you cant tell if they are short or not.

 

the Invidia G200 is a true dual exhaust..... 2 pipes from the cats all the way to the muffler... you would need 2 extension pipes, and the invida uses a weird piping diameter like 2.25" i think so the off the shelf one that Mynismo sells wont fit. it would definitely be cheaper and easier to get the G version