Need to know the stock or even the replacement size?

 

OK...There is a bracket and rubber...what are you looking for? The bracket cost from the dealer is about $12 and the rubber is $6. There is a fixed stud on the chasis and you would need a nut, which I believe is an 8x1.25 thread .

Other than that, the hanger itself is welded to the midpipe section and then goes into the rubber that is attached to that bracket.

So again, what are you looking for?

Rick

 

I heated and reshaped the pipe and bent the hanger so it gave me the clearance I needed. Thanks

 

Cool...I hate augmenting pipe like that though - it kills the structural integrity of it. Better having it bent at an exhaust shop the right way.

At least it's taken care of