Seibon TS hood install
#20
Guest
Posts: n/a
Wanna hear more about the spring? I'm seriously looking at these after seeing my friends hood on my car... Even his would bend a little if you put too much pressure closing it, I could see that messing up the clear coat after awhile. I'd end up getting hood pins a short while after. Can you take the hood latch off completely?
#21
#24
Guest
Posts: n/a
Hey guys, didn't wanna start a new thread since this is just a spinoff question...
Got the hood today and tried to put it on. Latch is up all the way and it's still a bitch to push down. WAY harder than my stock hood. Any sugguestions? I'm going to file the holes that the latch actually attaches to so I can move the entire assembly up some more. You think this will help?
Got the hood today and tried to put it on. Latch is up all the way and it's still a bitch to push down. WAY harder than my stock hood. Any sugguestions? I'm going to file the holes that the latch actually attaches to so I can move the entire assembly up some more. You think this will help?
Thread
Thread Starter
Forum
Replies
Last Post
R1 Autoworks
Exterior-Vendor
1
07-03-2019 07:16 PM
FS[SoEast]: 2006 DG Coupe Part Out - mrev2, projectors, etc
bu villain
Accessories
63
08-25-2016 07:14 PM