How hard is to replace the OEM turn signals with clear ones??

 

very easy... just pop em out and pop the clears in.. takes about 5 sec each side

 

thanks

 

Turn signals, or bumper lights? Bumper lights pop right off... turn signals have to have the headlight opened up, and the orange lens has to be dremelled out.

 

u just need 2 finger and a waste of 10sec from ur life...hehe

 

I'm kinda new to this whole thing so bare with me, I ordered the JDM clear corners. So whatever those are. Also After some searching, I went ahead and ordered the Ztube, with JWT pop charger. How easy are these to install? Also people mention a crawford plenum to ge the most out of intake mods. Where do I find this? Thanks for any help.

 

If your comfortable using a socket wrench and a screwdriver you'll have no problem installing the Z-tube/Pop Charger combo. There's probably a "how to" in the DIY section if you need any help. As far as the plenum is concerned there's a few options. Eithier replacing the entire thing and going with a Crawford, Kinteix, or APS or adding a spacer. Both will accomplish primarily the same thing.

www.crawfordz.com
www.kinteix-racing.com
www.motordyneengineering.com (spacer)