To install the front and rear splash guards did anyone here use a ramp, or is there enough room to drill holes on the side skirt and rear bumper without ramps....thx

 

You can do the front by just turning the wheels but for the rear they really need to be removed.

 

this might not be relevent, but i was able to take the front and rear
off without lifting the car.

 

you don't need to remove the wheels.

you can do the fronts by jacking up the car a little. A rt angle drill and short bit would make it easier.

You can do the rears with the wheels on by using a long extension bit and drilling at an angle....but you may find it easier if you take the wheel off.

 

i just turned the wheels one at a time for the fronts and i drilled for the other holes that was needed.. Before u put u pull the adhiesve tape off make sure the body doesn't have any wax on it or the tape will just not stick at all.. for the back i just jacked it up and took one wheel off a time and made sure there was no wax on the spot that the tape was touching