I honestly doubt it. The only method that comes to mind is drilling into the shift **** itself, but then you run the risk of making a hole in the button. Be sure you removed the white plastic cap from the shifter, as that make about an inch difference. Mine sits pretty low, and I've got it down as far as the lock will allow. Otherwise I run into the problem of the button not disengaging so I cannot remove the keys or sometimes take it into park. It was a huge trial and error to finally get it right, then tighten it so it won't ever move.

Hope this helps, good luck!

 

I want a shifter with a leather boot for my G@! someone post a link!

 

Here ya go!

http://www.redlinegoods.com

 

DVatz...that is what I'm aiming for! Beautiful install! I really like the outcome and am trying to acheive a similar end with my project! I PM'd you about my interest in your install.

Oh yea...and I'm going with black as well considering it should go well with my black leather interior!

Thanks for posting!
JD

 

I have the black Momo **** and really love it. I did however make a slight
modification to the actuator that keeps you out of reverse. I cut off about
an inch with my Dremel tool and shaped it like factory to lower the way the
**** sits.....it sits an inch lower now. Ordered mine from Jason @ Riverside
Infiniti 1-800-919-8130.....great price/delivery!

 

I'm thinking about getting that same Momo shift **** for my car too. It should fit nicely with my custom boot.

 

here is my 05 with the razo

 

How do you shift with the Razo design **** without the push button design? Do you push the whole housing down? Was it an easy install? Nice set up!

 

Do you guys know if you can put the plates from the 350z around that plate? Basically removing the whole plate, and just having the shiftboot and the 350z ring to hold it in place to give it a real MT look? I saw some 350z AT with that look not so sure about our G35s. If anyone knows, plz reply.

 

Where did you get that circle plate around the shifter?

 

I finished my install and hope to post pics very shortly. It turned out nice, although I do have some minor adjustments I'd like to make at some point to make it look cleaner. Overall, I'm very satisfied with the products used: I love the MOMO shift **** - 1000x better than the stock golf club ****, and Redlinegoods shift boot is awesome quality!!!!!!!!

Fitment is the only issue considering there is no specific installation method for the AUTO set up. I may end up converting to the Manual console (like jd2k1's setup) and use Redlinegoods boot instead of the stock one at a later date. Will post the pics ASAP!

 

Razo RA89

 

It's from the shift console on the MT.

 

I don't know about the 05+ but on my 04 I just push it down.

 

Here are some of the pics of my install. I still have some minor adjustments that I'd like to make when I find the time again to take apart the console. Excuse the quality of the pics, they were taken while at a red light with my Palm.