I've been searching for a while now but only found instructions on how to take off the door panel off of a sedan, but it doesn't

seem to be the same as the coupe. Does anyone have detailed instructions to take off the door panel in a coupe (with newer interior if it matters)?

The reason is because I want to reset the window motor. Thanks in advance.

 

You dont have to take off the door panel for that. Just roll your windows down and hold the button for 10 seconds and it will reset, Do the same when you roll them up

 

HUH? you mean the button used to roll the window down? who told you that? i'll go try it anyway just for the hell of it.

 

Now THAT didnt work.

 

yes it works when you roll down the window keep on the switch until you hear a click and when i clicks it will stop working for like 30 seconds and that means its reset

 

That is probably the sound of your motor circuit popping hahaha i have never heard of this, but w/e

-Sean

 

hmm it did make that clicking sound and it did stop working for a couple of seconds but I let it roll back up using the auto-mode

and it still went back down a quarter of the way on its own.

 

if you have a Fax machine I can send you the info...

 

I got this from alldata

DOOR FINISHER

Removal

1. Remove mask of inside handle portion and remove screws.




2. Insert taping flat-bladed screw driver into edge portion disconnect pawls and remove grip finisher.
3. Remove screw of grip portion.





4. Insert driver rolled with cloth between panel on vehicle and clips (as indicated with arrow) and remove finisher.
5. Pull up door finisher and remove power window switch and electrical parts connectors.




6. Remove lock **** cable and inside handle cable of inside handle assembly back side.
7. Remove inside handle screws and remove it from finisher. Lock **** cable
8. Disconnect metal clips and pawls from door finisher back side and remove power window switch finisher.

Installation
Install in the reverse order of removal.

CAUTION: To install finisher, check if all clips are matched over holes of panel on vehicle, then push it.

 

i'll PM you the fax number for my brother's house tomorrow cuz I dont have one. thanks man

 

thanks Scrooge. do those instructions take me to the window motor though?

 

Removal and Installation

FRONT DOOR GLASS AND REGULATOR


FRONT DOOR GLASS AND REGULATOR



REMOVAL

1. Remove the front door finisher. Refer to "DOOR PANEL".





2. Operate the power window main switch to raise/lower the door window until the glass mounting bolts can be seen.
3. Remove the glass mounting bolts.




4. While holding the door window raise it at the rear end to pull the glass out of the sash toward the outside of the door.
5. Remove the mounting bolts and remove the module assembly.





6. Disconnect the harness connector for the module assembly and uncap the harness from the back.

INSTALLATION
Install in the reverse order of removal.




INSPECTION AFTER REMOVAL
Check the regulator assembly for the following items. If a malfunction is detected replace or grease it.

* Wire wear
* Regulator deformation
* Grease condition for each sliding part

The arrows in the figure show the application points of the body grease.

 

i found this very useful

 

If you're looking to reset, the button is located in the middle of the door after you remove the door panel. Remove the round black sticker and you'll find it.
To reset, start with the window rolled up. Roll window all the way down (not auto mode) while holding reset button. Let go of the button and roll window back up (again, not auto mode).