I want to replace it due to the sun bending it but cant seem to figure out how to remove it.

 

im having the same issue to its annoying seeing that!!!

bump!!!

 

Tell me about Its a puzzle trying to figure out . Cant get it.

 

yes it is and I know we can't be the only ones having this problem!!!!!


Late night bumppppp

 

although I'll be honest to say I haven't tried myself I'll see if I can try Tuesday afternoon tho can't be that hard

 

Cool

 

Hey man I had the same problem. It was really annoying seeing it pop up and not be able to open the glove without having to pushi it down. I actually fixed it today without replacing it. The reason it does that is the factory glue is not holding it down anymore. I used a glue gun to reglue it. Super glue will not work because it is not thick enough. After applying the glue I put one of the warranty books in my glove box in the space and closed the glove box to push it down while it dried. I left it to dry for a couple hours and it worked perfect.

 

shoot it

 

Im going to try it thanks man I appreciated it.

 

so i finally go to doing this this past week, from what i saw you dont have to take the whole thing apart, just a few screws under the upper glove box door, i was gonna try glue but im gonna go and use a glue gun instead from what u say it works best since its thicker, ill try to take pics of this aswell

 

I tried to fix with hot glue gun...lasted only a week. So, can someone tell me how to remove the cover? There are 7 screws on the underside of the door...but it does not release the trim. I do not want to break it trying to take it apart. I do not have a shop manual yet...

 

i dint remove glove box, i just put plumers glue (stronger and more flexible than standar glue) and i used a grip for a few hours....the bending is gone and its worked for me, here are pics of what it looked liked and the results even days later....i pilled off the skin off the upper glove box compartment (only the affected area not the whole thing) and carefully put the glue in, then i used a grip and it turned out good i also used a couple of broken audio cd to stabilize the Grip tool and so it wont fall when driving, you DO NOT WANT TO PUT THE GRIP TOO TIGHT if so youll leave a dent on the compartment...see your yourselves







after a few hours....

 

^ what tool is that jdmg35sport? n where can i find one and how much?

 

ok so what about taking it out? anyone figure it out yet?

 

This is for an 03/04. I think you have to remove the center stack (radio and ac stuff) first.