Do you plan on doing the center console too? I just picked up silver jdm trim, and am most likely going to wrap that whole trim and center console in matte black. Was wondering how hard this would be since I have absolutely ZERO experience in working with any kind of this stuff haha.

 

Not sure if I am doing the console. It's very easy to apply on flat or one directional curved surfaces. Things that curve 2 directions will make it hard to get the wrinkles out and you will need to heat it.

 

I'm selling a couple of pieces that are oem black iso you dont have to worry about peeling or anything. I have the lower glovebox and the piece that goes under th steering column (where the hood release is) lmk if youre interested

 

Have you wrapped anything more?

 

I've done a few parts with the legitiment 3m stuff and it turned out great. I did the door pulls and window switch housings and they look fantastic, good enough to be factory. I started doing the center console. Haven't finished quite yet.

 

I tried to post a picture with my reply but it's not working :s I'll try and get something up tho

 

Wat did u use to paint the intererior!? Never heard of this n I'm interested.

 

This is what I used. SEM paint works wonderfully and has a dull oem finish. Just make sure you clean evrrything with alcohol and use adhesion promoter prior to spraying your interior parts

 

So you used 3m vinyl not material right? How is it holding up by the windows? I'm just about to get to wrapping all my interior parts. I'm thinking where you painted I'm doing carbon fiber. Where you did the carbon fiber, I may be doing suede. But how is it holding up with the padding underneath?

 

Cool thx

Is it easy to remove without damaging the interior?

 

Is what easy to remove, the paint? Idk ive never tried but why would you want to? It would be a mess and I don't think the panels would look the same with the paint removed. This paint is pretty strong