there is already a DYI on that - look in the DYI section. i know i've seen it.

 

I did not see it in there... I just looked again for it actually...

 

weird i swear i've seen it..

well write another one!

 

still havnt f'd with mine wheres the DIY?

 

oh jeez you lazy phuckerz!

open you hood, stand next to the fender, and look on top of your headlight housing. you will see a small 1/2" hole in the housing, with what looks white plastic gears. that's the up-down adjustment. you will need a 1/4" flat screwdriver to rotate it from the top - it's very difficult to get to it from the rear. park your car in front of the wall, and go at it! be careful not to break the gears - go slow.

 

which way to raise the aiming? clockwise?

 

i forgot. try it both ways, you can see pretty well which way it's going, especially if you're a few yards away from the wall.

 

new aiming question.. if this is how to aim your headlights. how can you aim the fog lights?.. i got HID fogs.. and they are bright!.. aimed really high on one side.. i dont even want them to turn on yet.. but yea.. HELP ! =(

 

there should be an adjustment screw for the fogs also, but you're gonna have to sniff all around your headlights to find it... good luck! /me grumbles about people putting HID fogs in their cars, losing high-beams, and blinding other drivers...

 

hehe .. i acutally got bixenon hid fogs.. that have high beam.s. but yea.. they blind.. i ha ve them off for now.. they are really high.. so i have ot aim them down.. anyone have a picture of where it is and such?

 

There are two holes when u open the hood. You need a Ling Phillips screw driver you sick it angled into the hole the one is for the low beam the other for the high beam. There is a round plastic guide inside each hole slide the screw driver right into it and u will head the little gears. The Phillips tip grooves turn the gears for u its super easy!!