Quad reto fit parts list
#1
#2
First you have to decide which projectors you want to use. Take a look at the ones on TheRetrofitSource site, that's where I get most of my parts. The low beam area is a little tricky to work with if you go with any projector that is not the Morimoto H1s. Anything bigger than those means that you're going to have to cut the stock housing to make the projector and shroud fit. The fog/high beam area is a little bigger and would be easier to fit a different projector there.
Up to you which projectors you want to go with, just remember that the stock housing is a little fragile and every time you cut it could mean that you'll end up causing it to crack somewhere. I've had that happen a couple of times.
Up to you which projectors you want to go with, just remember that the stock housing is a little fragile and every time you cut it could mean that you'll end up causing it to crack somewhere. I've had that happen a couple of times.
#4
Thread
Thread Starter
Forum
Replies
Last Post
FS[Texas]: KSport Air Suspension G35/350Z/M35
privatecorye
Steering & Suspension
1
05-31-2016 01:56 AM
DarkLyter
Brakes & Suspension
0
07-28-2015 04:57 PM
joedaddy1
Engine, Drivetrain & Forced-Induction
0
07-28-2015 02:58 PM