ConradoR's Progress Thread
#107
UPDATE
Bracket Blower and all Pipes Installed. Gauges done.
Thanks Danny Greengobbling for coming all the way from Miami and helping with the install Thanks Chris
Wed: Fuell pump and Injectors get here. (Sent to South Florida by mistake)
Thrusday: Fuel pump, injectors and cog belt installation
Friday: Tune & Oil Cooler + 4 Hour drive to Miami oh yeah
Before
After
:YaaaaaBuddy
Slammered Inc. Vehicles trophy sweep at Florida G Club Meet and Car Show
Bracket Blower and all Pipes Installed. Gauges done.
Thanks Danny Greengobbling for coming all the way from Miami and helping with the install Thanks Chris
Wed: Fuell pump and Injectors get here. (Sent to South Florida by mistake)
Thrusday: Fuel pump, injectors and cog belt installation
Friday: Tune & Oil Cooler + 4 Hour drive to Miami oh yeah
Before
After
:YaaaaaBuddy
Slammered Inc. Vehicles trophy sweep at Florida G Club Meet and Car Show
Last edited by ConradoR; 04-01-2012 at 09:15 PM.
#110
The following 2 users liked this post by ConradoR:
JaE35 (03-27-2012),
Princedrama (04-11-2012)
#114
Exterior is done unless I get new wheels, maybe just improve the stance of my current ones.
Interior: Headunit
Engine Bay: Continue working on it
Performance: BBK if I end up thinking that my current stopping power is not good enough for FI, wider/better tires if needed.
Def not trying to jump on any mods right now, will chill for a little to make sure nothing major breaks in the near future
#116
Yesterday: Received the Walbro fuel pump, DW 600 Injectors, and Uprev GT MAF
Last night: Bought the items needed to feed the boost gauge. Secured the hose for the BVP, got wires to extend the oil pressure sensor to the oil filter area.
Tonight: Installing boost gauge tee fittin & hoses. Extending and installing oil pressure sensor wiring. Preparing fuel pump for installation. Buying 10MM extended socket to avoid any pressure leaks from the T-Bolt Clamps by re-tightening them . Buying proper bolt for Mitsubishi Idler Pulley (similar to GTM Tensioner Mod Pulley), removing belt, installing pulley,removing unused pulley, and re-routing belt to revised setup.
Tomorrow: Installing fuel pump and injectors. Attaching oil drain hose, attaching oil pressure sensor hose, attaching bpv hose. Ready for tune.
Last night: Bought the items needed to feed the boost gauge. Secured the hose for the BVP, got wires to extend the oil pressure sensor to the oil filter area.
Tonight: Installing boost gauge tee fittin & hoses. Extending and installing oil pressure sensor wiring. Preparing fuel pump for installation. Buying 10MM extended socket to avoid any pressure leaks from the T-Bolt Clamps by re-tightening them . Buying proper bolt for Mitsubishi Idler Pulley (similar to GTM Tensioner Mod Pulley), removing belt, installing pulley,removing unused pulley, and re-routing belt to revised setup.
Tomorrow: Installing fuel pump and injectors. Attaching oil drain hose, attaching oil pressure sensor hose, attaching bpv hose. Ready for tune.
Last edited by ConradoR; 03-28-2012 at 09:35 AM.