ConradoR's Progress Thread
Joined: May 2008
Posts: 2,232
Likes: 162
From: South Miami
UPDATE
Bracket Blower and all Pipes Installed. Gauges done.
Thanks Danny Greengobbling for coming all the way from Miami and helping with the install
Thanks Chris
Wed: Fuell pump and Injectors get here. (Sent to South Florida by mistake)
Thrusday: Fuel pump, injectors and cog belt installation
Friday: Tune & Oil Cooler + 4 Hour drive to Miami oh yeah
Before
After
:YaaaaaBuddy
Slammered Inc. Vehicles trophy sweep at Florida G Club Meet and Car Show
Bracket Blower and all Pipes Installed. Gauges done.
Thanks Danny Greengobbling for coming all the way from Miami and helping with the install
Thanks ChrisWed: Fuell pump and Injectors get here. (Sent to South Florida by mistake)
Thrusday: Fuel pump, injectors and cog belt installation
Friday: Tune & Oil Cooler + 4 Hour drive to Miami oh yeah
Before
After
:YaaaaaBuddySlammered Inc. Vehicles trophy sweep at Florida G Club Meet and Car Show
Last edited by ConradoR; Apr 1, 2012 at 09:15 PM.
Joined: May 2008
Posts: 2,232
Likes: 162
From: South Miami
Exterior is done unless I get new wheels, maybe just improve the stance of my current ones.
Interior: Headunit
Engine Bay: Continue working on it
Performance: BBK if I end up thinking that my current stopping power is not good enough for FI, wider/better tires if needed.
Def not trying to jump on any mods right now, will chill for a little to make sure nothing major breaks in the near future
Joined: May 2008
Posts: 2,232
Likes: 162
From: South Miami
Yesterday: Received the Walbro fuel pump, DW 600 Injectors, and Uprev GT MAF
Last night: Bought the items needed to feed the boost gauge. Secured the hose for the BVP, got wires to extend the oil pressure sensor to the oil filter area.
Tonight: Installing boost gauge tee fittin & hoses. Extending and installing oil pressure sensor wiring. Preparing fuel pump for installation. Buying 10MM extended socket to avoid any pressure leaks from the T-Bolt Clamps by re-tightening them . Buying proper bolt for Mitsubishi Idler Pulley (similar to GTM Tensioner Mod Pulley), removing belt, installing pulley,removing unused pulley, and re-routing belt to revised setup.
Tomorrow: Installing fuel pump and injectors. Attaching oil drain hose, attaching oil pressure sensor hose, attaching bpv hose. Ready for tune.
Last night: Bought the items needed to feed the boost gauge. Secured the hose for the BVP, got wires to extend the oil pressure sensor to the oil filter area.
Tonight: Installing boost gauge tee fittin & hoses. Extending and installing oil pressure sensor wiring. Preparing fuel pump for installation. Buying 10MM extended socket to avoid any pressure leaks from the T-Bolt Clamps by re-tightening them . Buying proper bolt for Mitsubishi Idler Pulley (similar to GTM Tensioner Mod Pulley), removing belt, installing pulley,removing unused pulley, and re-routing belt to revised setup.
Tomorrow: Installing fuel pump and injectors. Attaching oil drain hose, attaching oil pressure sensor hose, attaching bpv hose. Ready for tune.
Last edited by ConradoR; Mar 28, 2012 at 09:35 AM.
Car's coming along awesome dude
