how much camber would i need to pull off a 19x9.5 et20 or 40 in the rear?

 

What tire size? I had -2.75 camber when I was running 9.5 +20 with a 255/35. With a 245/35 it would be around -1.75 to -2.0. With a 235/35 you'd be back within OEM spec for camber. This assumes your fenders are rolled very flat.

 

i was thinking a 245.. i want to stay around -2.0 to -2.5 bc thats where i am at now and have no excessive tire wear

 

You are pretty low, I forgot, so it will be a bit more camber than I noted. I was only lowered 2.5" back then. You'll be able to be within that range though with a 245 (one that runs small or true). You just gotta make sure you fenders are rolled really flat.

 

about -3.0?

 

Yeah no more than -3. TycoRC is running the same tire sizes and specs (and he's lowered 3" or so) I think he's at -3 camber. I think with a super flat roll though you'll be in the mid -2s. You could just go with a 235 to give you more clearnace, its hardly any stretch, same stretch as what I'm running.

 

Got New wheels . Pics soon. Back is nice and tight. Still working on the front. Can't turn with my spacers on, and I'm NOT raising it up!!!! **** that.

 

O specs are 20x9.5 et 23 but once my spacers are back on it will be et.8.
Back is 20x10.5 et 24

 

I am on springs so I have more compression than you probably and I am running 19.9.5 +30 rear at -2.5* camber. i still have about 4mm clearance and running a 255/35. I will be going 9.5 +25 and -2.75* camber. If you have your coils set to a stiffer setting you could easily do 9.5 +20 with a flat roll on 245s easily!

 

dznutz, what wheels did you get? Over/under is that you keep them for 3 months then switch up again.

 

only one for now.

 

Volks?

 

Cliff I didn't think you'd be able to run 20s at your ride height. You are definitely tucking rim in the rear...haha. Can't wait to see better pics.

 

Yea gt30's

 

You have good choice
Everything you do to your car looks sick !!