So, finally got my replica Impul kit and as expected the fitment is not 100%.

On the left side where it house the clear corner's, the hole is not big enough and on the right side, while the hole is bigger, its a little off.
Another troubling problem is where the foam absorber that runs across the entire front, I had to remove, just would not fit.
Also, the headlights are off but then again, I only screwed in 2 of 4 screws.

At first I did not like it but after I took a break from looking at it and relooked, I'm very pleased with how it looks. I'm planning to paint the lip black.

LET THE BASHING BEGIN!!


all shots
http://share.shutterfly.com/action/w...=9AcN27Fo5aMRQ

angle shot with splitter


angle shot without splitter



angle shot without splitter and side vent



front view with splitter


front view without splitter



side view, little off on the clear corners


close up shot of grill


full side view


this one for fun

 

need space to add pics later

 

need space to add pics later

 

Fix the pix man

 

^^ whats wrong with the pix, you can't see?

 

I say keep the splitter and lose the side vent

 

lose both..shave that licenst plate bar, get black mesh.

 

x2

looks good though

 

Silver or black that mesh looks like ***. Reminds me of a Honda back in the late 90's..

 

^^ thats what came with the bumper. Yes, the mesh looks like crap. Definetly getting that changed.

 

what does everyone think about this mesh grill

 

^^^ not sure you would have to do a side by side kinda hard to compare

 

a mesh with bigger holes, thicker lines, and plastic/// one closer to OEM size looks better.

 

wat erin said!

 

Way way way too much for a NA sedan.