Front: 19x8.5 +25 225/40
Rear: 19x10 +30 255/35

^^what are you dropped on? any fender work for those specs? What is your camber set at?

Fenders: Rear only
Susp: Tein S-Tech

Rear camber: -2.1
Front Camber: -1.8 and -2.1 if im correct. No camber kit. This is from my last alignment, over 1 yr ago.

any issue with tire wear without the camber kit?

yup, its always going to wear your tires. Just something you gotta live with.

Camber shouldn't be a problem, even with that amount. Just set your toe as close to 0 as possible you're good.

Yeah, i dont care about the camber as much as the toe.

in a previous post, i had been told to run 25mm front and 20mm rear, i just bought the eastwood fender finisher to pinch the hell out of rear...could i get away with 25mm all around?

Pinching the rear might be a little tough. Fronts are easy, but the rear is more difficult since the metal is thicker.

well shouldnt be too hard, considering it's already been rolled pretty nicely with a fender roller...it's just finalizing the roll to a pinch..my main concern is how much room i'll have available after it's done

Wheels look great cory.. but they look huge :-P

Cory, what are your fender to ground measurements? Looks good. Snoop, wheels probably look huge because the face extends completely out to the lip/tire.