Viktoria - 03 6MT Sedan
Yup, everyone said 18s would clear but I figured that was BS after it was too late, however they did clear with 20mm spacers. I just wasn't happy with how they look behind stock wheels and the vossens came up on a good deal.
Joined: Mar 2009
Posts: 18,299
Likes: 1,488
From: By the sea, Tx
G35 sedan w/ too much money in mods

My only suggestion would be to get some 10mm spacers for the front wheels so they come out closer to the fender to match the look of the rears. Other than that she's looking great!
Thanks man, I considered that option but I actually had to roll the rear fenders because they were rubbing so bad and I really don't wanna have to roll the front as well if I do spacers. Plus it's actually a little more flush than it looks, just the angle or lighting if this picture makes it look stranger.
Haven't been on the forum in a bit, finished basic training for the Navy in November and just been hanging here in Illinois going through some schooling for my rate. But here's an update: still have the sedan but motor was starting to crap out right as I left, burning more oil then before but nothing surprising for a 120,xxx mile vq. So after some debating of what to do with the car as far as a new motor with a boost setup (that was the plan), decided to pick up a new car and put the sedan on hold for a while. Turning the sedan into a project and when I have the funds together I plan to completely revamp the car and come back harder. As for the new car....2013 G37 IPL Malbec Black w/ Monaco Red interior 6MT ( one of very few black and red 6 speeds from what I understand) first owner took the car straight from the dealer. So far not much done just KW V3 coilovers, 20/25mm spacers, muffler delete, 3k hid fogs, and swapped all the interior/reverse/license plate lights with putco led's. Big plans for this car let me know what you think and check my build thread out on myg37!








Thread
Thread Starter
Forum
Replies
Last Post












