07+ G35X Wheel Pics Only
Originally Posted by ddubb
M35/45 19" Sport Wheels.


Did you grab these from ebay?
That's the only option I've seen so far.
Dealer is WAY too expensive for me!
Originally Posted by AesonVirus
I want a set of these SO bad.
Did you grab these from ebay?
That's the only option I've seen so far.
Dealer is WAY too expensive for me!
Did you grab these from ebay?
That's the only option I've seen so far.
Dealer is WAY too expensive for me!
Originally Posted by AesonVirus
I want a set of these SO bad.
Did you grab these from ebay?
That's the only option I've seen so far.
Dealer is WAY too expensive for me!
Did you grab these from ebay?
That's the only option I've seen so far.
Dealer is WAY too expensive for me!
I have 10mm spacers in the garage but they aren't on yet. These wheels fit without spacers but are a tad tucked into the fender wells. On the mudguard question, they came with the car from the dealer. And the spoiler is the euro one that I installed myself.
Hope that helps you guys out.
Originally Posted by 07BlueOnyx
Did you install the splash guards yourself or did the dealer?
The dealer shipped them to my house and I ended up installing them myself.
It's an easy install.
Trending Topics
Originally Posted by ChristianN
ddubb aren't you worried about the staggered wheels causing problems with the AWD system?
Originally Posted by AesonVirus
I ordered my G with Splash Guards, but they were never installed.
The dealer shipped them to my house and I ended up installing them myself.
It's an easy install.
The dealer shipped them to my house and I ended up installing them myself.
It's an easy install.
There's a few pre-existing holes, you just pull the plugs out and use the included screws to attach them.
There is one screw beneath which requires drilling.
My cordless drill is huge, so I had to jack each corner of the car to get the drill and bit beneath.
The kit includes a paper template for where to place the hole, but I put my guard in place and double checked the hole location before drilling.
Once the hole is in place, be sure to have a super clean surface (I used an Alcohol/Water solution) cause these also have some double side tape.
Put them in place, pull out the tape backing and zap in the screws.
I think it took me about an hour or so and that was only because I had to jack the car for the bottom holes.
Otherwise, it's a 5 minute/1 beer process.
There is one screw beneath which requires drilling.
My cordless drill is huge, so I had to jack each corner of the car to get the drill and bit beneath.
The kit includes a paper template for where to place the hole, but I put my guard in place and double checked the hole location before drilling.
Once the hole is in place, be sure to have a super clean surface (I used an Alcohol/Water solution) cause these also have some double side tape.
Put them in place, pull out the tape backing and zap in the screws.
I think it took me about an hour or so and that was only because I had to jack the car for the bottom holes.
Otherwise, it's a 5 minute/1 beer process.
Originally Posted by ChristianN
ddubb aren't you worried about the staggered wheels causing problems with the AWD system?
Thread
Thread Starter
Forum
Replies
Last Post
Cajuncowboy
G35 Sedan V35 2003-06
36
Jun 21, 2021 09:47 AM
kinetek
Brakes & Suspension
9
Aug 3, 2015 04:25 PM





