Anyone know how much it would cost to get mrev2 and 5/16 spacer installed on my 6mt g35? Does anyone know any good installers in the bay area or davis area.

Thanks

 

It is an easy DIY but might cost you ~$150-200 to install.

 

How easy is easy? I'm new to this kind of stuff. I've never really installed anything on a car before.

 

you can turn a ratchet you can do it.

 

I looked over the installation instructions and I'm not sure if I want to do the install myself. Does anyone know a place that I can get it done?

 

You in Davis, I in Fairfield. We're in the middle of nothing as far as shops go.
There was 2Visions Racing in Concord, but they're no longer.

Check out the sticky post in this section.
https://g35driver.com/forums/nor-cal-g/156204-unofficial-bay-area-automotive-shop-directory.html
but again those shops are nowhere near us.

Just thought of Mod-a-Car out in Livermore, but again, not close to us.

G/L

 

you need an in-lbs torque wrench. it's easy if you take your time.

 

got a garage??
how soon you need it installed??
you willing to get your hands dirty??

i could help, i just gotta go get my inch-pound socket wrench from my cousins...

should take no more than 2 hours... that's how much time i took, being that i went slowly and had to wait till i got a helping hand to hold the upper plenum...

 

some cold 1's and your all set

 

bring it to the bbq and i am sure we can install it lol

 

i haven't even picked up the parts yet but i just wanted to get an idea

 

DIY it's real easy. If you can install an intake you can definately do this.

 

i don't have a garage actually.. but i don't mind doing it with someone else im just scared to fk up if i do it myself