Osiris Install
#25
Join Date: Dec 2007
Location: Bay Area, CA
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Baseline test and install today, not too bad. Put down 198 rwhp & 196 tq on the base Osiris map.
Mustang 4wd Dyno, ambient temp: ~55, 91 octane.
Turns out my 2006 ECU is different than most g35 ECUs, so I'm going back to EIP next Saturday for a better map and hopefully more power.
Mustang 4wd Dyno, ambient temp: ~55, 91 octane.
Turns out my 2006 ECU is different than most g35 ECUs, so I'm going back to EIP next Saturday for a better map and hopefully more power.
Last edited by koolaid80; 01-19-2008 at 04:24 PM.
#27
Not on this dyno... correctly calibrated AWD Mustang dynos have been known to read really low, this one reads a bit lower for some reason. But that is a good thing for tuning.
BTW, I don't think I raised the rev limiter... if I did, it was only a few thousand RPMs.
Koolaid, by the looks of your numbers, I'm guessing you don't have a revup? That looks like just a baseline and flash, no tune yet... I think that's why they want you back next Sat.
BTW, I don't think I raised the rev limiter... if I did, it was only a few thousand RPMs.
Koolaid, by the looks of your numbers, I'm guessing you don't have a revup? That looks like just a baseline and flash, no tune yet... I think that's why they want you back next Sat.
#28
Join Date: Dec 2007
Location: Bay Area, CA
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
I do not have a rev-up engine, it's a 5AT Sedan. There's definitely no tune yet; Paul had to grab all the data off the Cipher datalogger and send it to Uprev so they can make a map for my car. Hopefully after the tune I'll be near 220, but we'll see. That increase in torque is definitely noticeable on the low end.
#29
Originally Posted by dofu
Not on this dyno... correctly calibrated AWD Mustang dynos have been known to read really low, this one reads a bit lower for some reason. But that is a good thing for tuning.
BTW, I don't think I raised the rev limiter... if I did, it was only a few thousand RPMs.
Koolaid, by the looks of your numbers, I'm guessing you don't have a revup? That looks like just a baseline and flash, no tune yet... I think that's why they want you back next Sat.
BTW, I don't think I raised the rev limiter... if I did, it was only a few thousand RPMs.
Koolaid, by the looks of your numbers, I'm guessing you don't have a revup? That looks like just a baseline and flash, no tune yet... I think that's why they want you back next Sat.
wow only and a few thousand rpm shouldnt be int eh same sentence lol
#30
Join Date: Dec 2007
Location: Bay Area, CA
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts