fender rolling
#32
Originally Posted by Andy2434
Unless you seal the cut edges really well, they will eventually rust.
Cutting vs rolling fenders...
When you're rolling the fenders, there is a chance you can pull the fender, leaving the two sides uneven. I don't care how many fenders you've rolled, or if you're using a machine or not, it can still happen. The machine is really nothing spectacular... bolts on to your rotor, and a wheel rolls the fender as you pull it outward. Personally, I would prefer rolling a wood baseball bat over a wheel still...
Cutting, you'd have to worry about rust. But if it's sanded and sealed correctly, then you have no problems at all to worry about.
#34
Thread
Thread Starter
Forum
Replies
Last Post
THMotorsports
Suspension-Vendor
257
12-18-2018 05:43 PM