Adding some new stuff to the car.
Joined: Jan 2004
Posts: 3,744
Likes: 72
From: California
Adding some new stuff to the car.
Well as I am bored and have nothing better to do with my money I decided to upgrade a few things on the car.
Probably some time in June I will be adding the following items;
GTM stage 2 cams
11.00 mm Peak Lift
232 deg. Dur. at 0.050" lift
272 deg. Adv. Dur.
New 06 lower plenum from Nissan with the shorter runners.
Also contemplating going to external wastegates but need to think about that a little more.
Having the rims powder coated black like this;

I also have the Greddy sideskirts sitting here in the garage and waiting on my CS bumper from Eric to arrive so I can get them all on at the same time.
I have 10mm spacers to install but need my fenders rolled.
Lastly I will install my Works Bell paddle shifter which I have had for months.
After that I think I am done with this car, spent enough on it already;
Engine
Resurfaced cylinder head with an RA finish
New viton valve stem seals
HKS head gasket
Wiseco® Extreme Duty pistons 8.5 compression
Carillo Forged Rods
Mag and micro polishing of the crankshaft
Balancing of the rotating assembly
Rear main seal assembly
GTM® Race bearings (standard bearings)
ARP® 2000 11mm head studs
Crawford Plenum 5/16" Spacer
Deathwerks 660cc Injectors
Walboro 255lb Fuel Pump
APS Twin Turbo System
GTM ECU Reflash
Blitz SBC Boost Controller
Upgraded actuator springs (red)
HKS FCON V Pro
HKS F CON Navigator
Fast Intentions Intimidator exhaust and test pipes
Greddy Catch Can
Stillen Upgraded oil cooler
JDM Right Hand Battery Cover
NRG Hood Shocks
Suspension
GT Spec Rear Lateral Brace bar
Front and Rear Stillen Sway Bars
SPC Front Camber kit
SPC Rear Camber Arms and Toe
Tein CS Coilovers
Tein EDFC
Transmission
GTM Upgraded Tranny Internals
GTM Upgraded valve body
Edge Racing Upgraded Torque convertor
B&M Upgraded Tranny cooler
Brakes
Wilwood SS brakelines
Wilwood 6 Piston 14" Rotor Front Brake kit
Wilwood 4 Piston 13" Rotor Rear Brake Kit
Wheels/Tires
Project Kic R40 Neochrome lugs
Volk SF Challenge 19x9.5 & 19x10.5
Khumo SPT 245/275
Exterior
Klumzyee Greddy Sideskirts
06 Projector Headlights
Philips Xenon 6000k Ultinon Bulbs
Sony Reverse Camera
KP Technologies Tilt Down Mirror Module
KP Technologies Roll Up Window Module
Kuruma Z Front Bumper
Klumzyee Roof Spoiler
Just going to make sure I can add another 100,000 miles on the car and get my moneys worth
See you guys at some future meets.
Probably some time in June I will be adding the following items;
GTM stage 2 cams
11.00 mm Peak Lift
232 deg. Dur. at 0.050" lift
272 deg. Adv. Dur.
New 06 lower plenum from Nissan with the shorter runners.
Also contemplating going to external wastegates but need to think about that a little more.
Having the rims powder coated black like this;

I also have the Greddy sideskirts sitting here in the garage and waiting on my CS bumper from Eric to arrive so I can get them all on at the same time.
I have 10mm spacers to install but need my fenders rolled.
Lastly I will install my Works Bell paddle shifter which I have had for months.
After that I think I am done with this car, spent enough on it already;
Engine
Resurfaced cylinder head with an RA finish
New viton valve stem seals
HKS head gasket
Wiseco® Extreme Duty pistons 8.5 compression
Carillo Forged Rods
Mag and micro polishing of the crankshaft
Balancing of the rotating assembly
Rear main seal assembly
GTM® Race bearings (standard bearings)
ARP® 2000 11mm head studs
Crawford Plenum 5/16" Spacer
Deathwerks 660cc Injectors
Walboro 255lb Fuel Pump
APS Twin Turbo System
GTM ECU Reflash
Blitz SBC Boost Controller
Upgraded actuator springs (red)
HKS FCON V Pro
HKS F CON Navigator
Fast Intentions Intimidator exhaust and test pipes
Greddy Catch Can
Stillen Upgraded oil cooler
JDM Right Hand Battery Cover
NRG Hood Shocks
Suspension
GT Spec Rear Lateral Brace bar
Front and Rear Stillen Sway Bars
SPC Front Camber kit
SPC Rear Camber Arms and Toe
Tein CS Coilovers
Tein EDFC
Transmission
GTM Upgraded Tranny Internals
GTM Upgraded valve body
Edge Racing Upgraded Torque convertor
B&M Upgraded Tranny cooler
Brakes
Wilwood SS brakelines
Wilwood 6 Piston 14" Rotor Front Brake kit
Wilwood 4 Piston 13" Rotor Rear Brake Kit
Wheels/Tires
Project Kic R40 Neochrome lugs
Volk SF Challenge 19x9.5 & 19x10.5
Khumo SPT 245/275
Exterior
Klumzyee Greddy Sideskirts
06 Projector Headlights
Philips Xenon 6000k Ultinon Bulbs
Sony Reverse Camera
KP Technologies Tilt Down Mirror Module
KP Technologies Roll Up Window Module
Kuruma Z Front Bumper
Klumzyee Roof Spoiler
Just going to make sure I can add another 100,000 miles on the car and get my moneys worth
See you guys at some future meets.
Joined: Jan 2004
Posts: 3,744
Likes: 72
From: California
To date probably 35k
Trending Topics
Registered User
iTrader: (10)
Joined: Jul 2006
Posts: 3,942
Likes: 7
From: PNW in Washington
6MT Coupe
Ah yes, finally going for those stage 2 heads 
"New 06 lower plenum from Nissan with the shorter runners"
Is that like the 'rev-up' lower collector or something different.

"New 06 lower plenum from Nissan with the shorter runners"
Is that like the 'rev-up' lower collector or something different.
Joined: Jan 2004
Posts: 3,744
Likes: 72
From: California
Not looking to break any records but anywhere in the 500's on pump gas would be great
Yes that is what it is, the rev-up lower collector, should pick up some nice HP numbers with this and the cams. Instead of power dropping off at 6000rpm it should be good all the way up to 7000rpm now.
Not looking to break any records but anywhere in the 500's on pump gas would be great
Not looking to break any records but anywhere in the 500's on pump gas would be great

Talk about a sleeper!I love it.





