Who is interested in a fender rolling day? I would be able to offer the service if anybody wants to host. I'm in the north bay and I can also host but It might be too far for some people. Thoughts?

you think you'll be able to roll my already cut fenders for the rear? i cut these like 6 years ago now in regrets

Yes, they might be a bit more flimsy depending on the way it was cut. I might have to do a couple tack welds so the lips don't separate.

I'm down for some roll

Does a fender roll have soft shell crab or yellowtail?

sounds good, i want a slight pull like my front. lmk when you do this

I'm available almost every day in the North Bay. If we can all decide on a day, I can do a lot of cars.

ill pm you

I'm interested if this works out. Post up a date if it does happen.

How does September 13-14 work for everyone?

Rubber mallet works just fine.

Where is it going to be at?

It will be in the North Bay unless anyone else can host closer to the Bay Area.

Should I come by tomorrow?

Did this ever happen?