Thank god for Motordyne! hehe.

drove to Everett at 2am to pick up some staggered 19's. instantly drove home at about 6:30 and got home at 11:40 crazy cold/rainy weather you Seattle guys are having. 10 hours of driving straight for 19's FTW!

Do I even need to say it Cam!?

ha ha here you go shank



19x8.5 for the front 18x9.5 for the rears.As you can tell the lips are a little beat up so powdercoating will be the first thing on my list, then Im picking up a set of 245 35 19s within the next month here and then after all the snow it'll be time for them to go on :-)

i can honestly say ive never owned a set of rims with a three inch lip until now lol

stage 2 stoptechs just came in today. Im going to and put them on tomorrow at school.

Ordered polished JDM engine harness, Greddy Air diversion panel, and recieved a stillen engine damper brace (thank you Cersoft). Thats all for this week folks...oh and i dusted it before driving it yesterday cuz the weather was off the hook.

Thats right, last night, I rolled over, looked at my wife and said "I'm gonna tap that A$$ tonight." To which she replied, "That's nice honey"

So I proceeded to jack that rear end up and took a nice long look at that rear.
Sitting next the rear was my un-opened Fast Intentions exhaust that came in that morning. I looked at the OEM exhaust on my 05G35 Coupe and proclaimed to my baby, that A$$ is getting worked tonight.

When it was all said done, we both lay there, satisfied, her purrring with new exhaust and me proclaiming my manhood once again. Now the A$$ of my G has a nice new set of polished tips to go with the FI exhaust that lay under it. It was a good evening had by all.

LElzie..that is friggn hilarious..nice ..always appraciate sarcasm with hard work.

Fast Intentions is legit.

next time go here

installed JDM engine harness and Greddy Air Diversion Plate yesterday morning...tryin to make the engine bay a little cleaner. Engine damper brace is being a pain in the ***!!!!!

took my test pipes off the car and put the stockers back in....

Sent my ecu to Technosquare today.

It's been about a year since I've been in there. Since my TCM sits in the same area, I almost sent them my tranny ecu by mistake. lol

Dropped it off at Intec Racing for some... "upgrades"

CP pistons
Carrillo rods
ARP head studs and mains
Cosworth bearings
HKS head gasket
CJ motorsports fuel return and twin-pump assembly
1000cc injectors

Ohhhhh baby here comes the boost