^You gotta buy the entire set Monard, they are not sold individually.

 

really? they dont sell it by 3 piece only? your using the same marcus? where u got it?

 

Bought them from here: https://g35driver.com/forums/accesso...-hose-kit.html

They only come in a set of four.

 

ok coo! thanks bro!
im looking for engine mods coz i got a new engine so i might aswell install most of it while the car is at the dealer. gonna get sean's polished TC too

 

Yeah might as well do everything you can while they are putting things back together. Congrats on the TC, gonna look dope!

 

yeah! but i havent gotten it yet. hopefully sean can pull it off for me
need it next week to drop off at the dealer

BTW marcus you have close up pic of your ARC catch can?
how did you mount it?

heres a pic of sean's polished TC on a rev up engine

 

Monard, here are a couple of pics that show the custom RareJDM bracket (pictured to the left of the oil catch can). Zack (zackt69) and John (speedraver) are running the same bracket too if you search for pics of their bays.

 

^^Thanks marcus!

 

Chris , I saw you car at Randy’s the other day… Oooooo Weeeee! That engine bay is HAWT!!!! Post pics of that bad @ss bay!

 

And if you get it from MSA (thezstore.com), they come with both rad overflow hoses (g and z)… but the Z hose does have venair all over it

 

Thanks Mike

My engine bay still has a long way to go before its picture ready though...its hard to compete with all the bays posted up in this thread

 

try these guys: www.thezstore.com

The are local - in Orange, near the Honda Center - so you dont have to pay for shipping

 

no dude, your bay has every bit the reason to be in this thread! I was very impressed!!! (for what thats worth ) I'd post if it were my bay!

 

So i decided its about time i start my wire tuck...how hard can it be. This is the progress so far. Only the left wheel well so far. Any suggestions are welcome
( And yes, everything will get very thoroughly cleaned afterwords )






I have to admit that this is more work than I was expecting I took my time to de-pin every single connector, extended the headlight harness by 10 inches, and tried not to cut any corners.

 

thanks mike!