I am lowered on BC coils.

I dont know what people are talking about when they say BC coils dont lower enough.. I am not even maxed on these things and I still have a good 2 more inches to lower in the rear. The front I believe I have another inch.

Here is a picture of the back

 

Back in the day when I was running 20f 30r spacers. Thats on the same height setting before and now.

 

What is your camber specs??

 

Fronts are on the verge of being off factory specs. I believe its -1.3-5ish. The rears are off spec -2.5-6ish.

 

I'm trying to figure out the biggest spacers I can run on stock camber with just the rear fender lip grinded smooth..

 

 

 

What size spacers do you have now and how much room to your fender is left?

 

Damn those chrome 19s are looking very nice on your G.

What spacers are you running?

 

40+ easy. I had 38mm and that wasn't super flush and and camber was -3.1. The stock camber can be adjusted more into the negative.

 

would say a 30-38 and adjust camber positively you'd be flush

 

Thanks man. I'm on 25 f/r. May go up to 30/38 if I don't get some wheels by this summer. Planning on dropping the rear a bit more so itll be even with the front once I roll the fenders. Didn't get the chance today.

 

I would say a 20f and 30r setup would fit you nicely frankie.

If you go any bigger in the rears, youre going to have to run some negative camber. 30mm should get you close to stock specs in the rear. 20mm on the fronts should be fine with stock specs. 25mm might be close to stock specs.

Ive played with all sorts of sizes already but then again my rear fenders are rolled.

 

 

I'm running 30/35 now with a little over -2 camber.. Plan is to put the 30 on the rear and get 20/25 for the front.. Gonna raise my car some too, I'm tucking 35 series tires and my undercarriage hates me for it..