Picture Request: Coupe Dropped on 350Z H-Tech With No Springmount Mod
#16
1 - don't get the G H-tech. Terrible spring rates and next to no drop.
Here is my car the day after the 350Z H-tech install... may have settled slightly since then, but not much. I won't be doing the springmount mod.
Just got aligned and rears are back in spec. Fronts are in spec except for camber of -1.3 and -1.4. I'll live with it.
Here is my car the day after the 350Z H-tech install... may have settled slightly since then, but not much. I won't be doing the springmount mod.
Just got aligned and rears are back in spec. Fronts are in spec except for camber of -1.3 and -1.4. I'll live with it.
#17
Algy,BlueDevilBAMF. You guys' Z h-tech drop dont look extremely uneven too. BlueDevilBAMF,do you have higher profile tires in the rear?
From most of the people, alignment can get close back to spec if no springmount mod.
That's it! I'm ordering a set of Z h-tech tomorrow, along with some Project Kic spacers (20mm front /25mm rear).
From most of the people, alignment can get close back to spec if no springmount mod.
That's it! I'm ordering a set of Z h-tech tomorrow, along with some Project Kic spacers (20mm front /25mm rear).
#19
#21
#23
#25
#27
#29
Originally Posted by fullvietFX
For the Z H-Techs, without the springmount mod does it drop more in the front or the back?
#30
I finally got my Z H-Tech installed along with 20mm/25mm spacers, I'm happy to say that my drop is pretty even on the front and back. The drop is just like Algy and LazerRed1's.
I have about a tiny less than 2 finger gap front and back, except the left-rear side have exactly 2 finger gap. I wonder if it's because I only have quarter tank of gas, since the gas tank is in that location?
Will post pics tomorrow!
I have about a tiny less than 2 finger gap front and back, except the left-rear side have exactly 2 finger gap. I wonder if it's because I only have quarter tank of gas, since the gas tank is in that location?
Will post pics tomorrow!