UC Riverside Meets Thread
#4384
#4386
Registered User
iTrader: (1)
Join Date: Oct 2009
Location: So Cal Riverside
Posts: 178
Likes: 0
Received 0 Likes
on
0 Posts
I just don't get it why my dam 3puke started acting up after a just a year when i drove it fine! I got ripped off
#4388
Registered User
iTrader: (25)
Are you still on stock block? I'm assuming your rev limiter was raised? If so, running the 2.87 pulley puts you in risk of over-spinning the blower if you're revving up to 7k+ rpm. Personally, I'd do the smaller pulley and have my tuner lower the rev limiter. The smaller pulley will bring on the boost sooner too. But you have to be careful of making "too much power" on the stock block.
The headers will give you more HP in the top end, as well as lower your max boost psi (which is good for the engine). But again, consult your tuner about making 'safe' power.
The headers will give you more HP in the top end, as well as lower your max boost psi (which is good for the engine). But again, consult your tuner about making 'safe' power.
#4389
#4390
#4395