She's going down this weekend...and the car.
Joined: Jan 2008
Posts: 383
Likes: 0
From: Cornelius, NC
I'll work on it soon. I want to see if the rear settles in a little more. So far it hasn't done a lot, but I know it takes a little time. I def need to get the car in for an alignment. I'll try to get outside one night this week and snap some photos.
Spread the word about this weekend, it should be a good one! Last weekend = FTW!
Spread the word about this weekend, it should be a good one! Last weekend = FTW!
hey brian you should post up a thread on the G forums letting everyone know about saturday plans to hickory. I think i have to more Z's that want to caravan with me you an john to hickory
Well I have my paint and my angel eyes. Debating on whether to wire up a switch or just hardwire them in when turning on the parking lights. Only other concern is when I go to reheat the headlight to seal it back up, worried it may have negative affect on angel eyes.
Well I ran into two roadblocks. One: ran out of paint 12oz can is not enough, so passenger side headlight is not done to perfection. Two: Stupid halo for upper light is to small, looks to be the size for a coupe. One of them broke in my hand when I tried to position it on the headlight. Suck ****.
I am happy with the lower halo, will only be installing those, they fit the bottom light well.
So if your in the market for halos, pay the money and get the exact fit ones, prefer the more flexible kind, go cheap and suffer the consequences.
I am happy with the lower halo, will only be installing those, they fit the bottom light well.
So if your in the market for halos, pay the money and get the exact fit ones, prefer the more flexible kind, go cheap and suffer the consequences.
I am done. I think it looks goods even if there are minor blemishes, I m probably the only one that will notice.
Only had one other mishap, when I was putting on the bottom halos. I went to cut a slot in the headlight frame and put a crack in it while cutting, derrrnnn. Oh well.
None of these blemishes are not noticable unless you really look hard for them.
Only had one other mishap, when I was putting on the bottom halos. I went to cut a slot in the headlight frame and put a crack in it while cutting, derrrnnn. Oh well.
None of these blemishes are not noticable unless you really look hard for them.






