Ive been calling and looking around for a good shop to get my Headers installed and maybe exhaust and I looked up GT Motorsports, I am just wondering if any of you guys had any work done by them. I called them about my headers install and they told me i was looking at little less than $600.

 

A ton of guys here have....

 

go to Home Depot and get an Amigo to install it for $30

Just playin... i dont know... you can try one of those all around Mechanic shops!!!!!

I know a guy in Buena Park that would probably do it!

 

I'm not sure I would go with GTM for just header & exhaust install. They are top notch at their work, but for header & exhaust installs, you can get it done somewhere else for probably less. Not only that, but they are usually very busy. I don't think header installs is worth the trip to GTM (IMO).

Now, if I were going Forced Induction or was getting internal engine work, then they would definately be my #1 choice.

 

I bet Fast Intentions would do it.

 

GTM does top notch work and I wouldn't go anywhere else but GTM, but the thing is, I personally would not go to GTM if I'm NA Unless I'm building my motor or going FI then I'll go GTM, otherwise I would go somewhere else for headers etc. I honestly think those are too much of a small job for them haha, but then again if they have time to do it, then good for you!!

 

street image did mine for around half that. just fyi.

 

+1.

 

Yeah thats nothing new, GTM is a high dollar shop and charges the most for labor per hr, but its worth every dollar. But it might not be worth it to the O.P if its just headers and exhaust for the price he would pay, theres only one way to do it and plenty of places can get those things done right. But if you have GTM do it, then heck your mind will definitely be at ease though For smaller work I recommend my friends to go to Corner 3 Garage in Lake Forest, I would go there also for any NA/Bolt on jobs, but my car is long gone past that so only gtm can touch it now

 

Go to Technosquare in Torrance. They will get it done right and in a timely manner. http://technosquareinc.com/

 

I think R&D factory could do it. There are quite a bit of us here in the LA area who have been there now.