Hi everyone,


I currently running 285/35R19 in the back and the rear fenders are rubbing, I hoping that rolling or shaving the fender will stop it. I am running stock height if that makes a differece.

I need my rear fenders rolled for my coupe. Any one know of a good place to go to get my fenders rolled in the 909 area?

Robert

 

What is the wheel width and offset?

 

19x10.5 + 17 (Volk SF-Winnings)
and the tire is 285/35 Nitto INVO

 

shanesg is the man to go to for fender rolling. but with that said, i'd highly recommend cutting your fenders than rolling them.

 

+1 for shane

 

where is shanesg located?
Does he have a shop?

Thanks

 

Yeah, you definately need to roll your fenders.

ShanesG is THE man for the job. PM him and tell him to set up a 909 roll day at my house.

 

If that happens, I'll get my fenders rolled too for my future wheels

 

Thank for the help all,

I went to tuning technologies in colton, they supposed to open at 9, I waited until 10 and still not open so I bailed, and went to VIP-Status, they cut my fenders cost a bit at 45 a fender, but no more rubbing!

Thanks again,
Robert

 

^Dang you traveled almost across the whole SoCal! But cool you got it done.

 

I'd like to sign up if there's a 909 fender roll day. Thank you.

 

Put me on that list too i need my fenders rolled asap!

 

cutting looks better, anyway. mine are cut and i would never have 'em rolled.

 

i can roll or cut fenders at my shop its in ontario i rolled mines then added rubber seal so if it were to rub it wouldnt cut the tire 909.994.6699

 

If there is enough interest and Sean would be so generous to open his garage, i'd love to come out and do a roll day for you guy. I was actually just about to start a thread since i've been getting quite a few PM's from OC guys. Lemm talk to sean and see what we can do. I also do basic installs so if there is enough time and not a bunch of rolls we could squeeze some of that in as well.

As for cutting vs rolling either one gets the job done. My rolls look just as good as cutting IMO since i roll almost all the way around the fender. Also i've had guys come to me who have got their fenders cut to get them rolled cause they started rubbing when they finally got more aggressive wheels ugh and it's a PITA cause most shops will refuse to cut it all the way and still leave a lip there.

If 5 or more people can sign up i can reduce the price as well.