So I've been diving through threads and have pretty much come to the conclusion that I should go with a NISMO clutch & pressure plate, flywheel, roller bearing, and braided clutch line. I see between http://www.importpartspro.com and http://www.thenismoshop.com I can get the majority of the parts but, I can't seem to find the pressure plate. Any suggestions?

And as a piggyback question: I reside in Pomona - anybody know of a good shop that can install all this for me or maybe even order and install the parts? Appreciate you guys help!

 

If I were you I would border the SpecialtyZ flywheel (best I've seen for the G and low noise) and a matching clutch....comes with throughout bearing...

Specialty.com

 

Appreciated, but I'm pretty set on the NISMO setup.. Thank you though. Looked in the SoCal Shop directory but the only shops close to me, that are listed, haven't contacted me back yet about it.

 

That pressure plate is pretty elusive. They are getting very hard to find. This link looks like they have it but I'd definitely call to confirm or at least shoot an email.

http://www.yournissanparts.com/catal...82187&detail=1

If not contact vivid and speak to a sales rep. I know for sure they can get it but it's pretty pricey through them.

 

Thanks! I'll definitely get in contact with them - Hope they have it. Would you happen to know an installation shop that could do this? The places I've spoken to have said like $800 and I'm hoping for cheaper, if possible.

 

they are all roughly going to be around that price at a shop unless you have some type of hook up. Dont know if you are handy and have a friend with mechanical know how and a lift but it is possible to do yourself. people even do it on just jackstands. i dont know what your plans are in terms of power but i was seriously about to get this but then decided against it because it wouldnt be enough for my FI needs. also if you really want to avoid chatter which is why im assuming you are going with the nismo flywheel, id just try to find a place that will resurface your dual mass stock one and run it with the nismo clutch.

 

also if you are going with the entire subtle nismo theme, id definitely try to find an s-tune catback. but ditch the Y and mate it with a different one, Hr or xyz.

 

R&J in Carson can do the install...PM for price and scheduling.

 

Just an update:

Finally received all my parts (12310-RSZ30, 30100-RS252, 30210-RSZ30, 46211-RSZ30, 32202-09500) and am getting it installed for the hookup price of $350. Thanks to everybody who commented and helped!