1 minute project:

Lift up shifter boot bezel:


Slide cup holder assembly forward:


Lift cup holder assembly up to disengage 2 clips on each side. The slots for the clip are visible at the bottom of the picture:


Finally, disconnect connectors to buttons

 

How difficult is it to remove the shifter boot bezel in step 1? I have tried and it wont budge. It doesn't seem to want to give. I do have the wood grain interior but I wouldn't think that would Matter.

 

same here. have any luck?

 

also noticed that you don't have the "SNOW" switch...was that an option?

 

Only the AWD get the snow switch... I believe.

 

Step 1 is to remove the shift ****, the bezel wont go anywhere with it still on.