DIY: LED Front Turn Signal Blinkers
#16
Not knowing anything about switchback I had to google it. I think I see how it works, and I'd assume you would need to go 7443. 7440's are only good for off/on. 7443 would be needed to do the three possible conditions of off/amber/other color. You'd also need to figure out a way to send the signal to the socket, should be easy enough to do, but right now the socket only knows when to turn on (amber) or off. If it is 7440 now that means you would have to power the second circuit to be the other color.
If you switch from halogen to LED I'd guess you'd still need the hyperblink fix as halogen still pulls a higher amp load from the circuit so the car still "sees" the bulb in the circuit. Once you go LED the amp load is so low the car thinks the bulb is not there or burnt out so it hyperblinks as a warning to replace the bulb..
If you switch from halogen to LED I'd guess you'd still need the hyperblink fix as halogen still pulls a higher amp load from the circuit so the car still "sees" the bulb in the circuit. Once you go LED the amp load is so low the car thinks the bulb is not there or burnt out so it hyperblinks as a warning to replace the bulb..
#22
Thread
Thread Starter
Forum
Replies
Last Post
Luisgalvan33
G35 Sedan V35 2003-06
3
07-19-2018 08:16 PM
MyfistYourFace
G35 Sedan V35 2003-06
4
08-08-2015 11:58 AM