Registered User
So are these are washable like K&N filters? are new replacement filters available as well?
Here's a dyno graph for ya, bone stock.

Make sure you post the dyno results.
Here's a dyno graph for ya, bone stock.

Make sure you post the dyno results.
Registered User
Quote:
Originally Posted by G35octane
so can i put dual intakes on a 2003.5???????????????/
NO MAN WHATS WRONG WITH YOU!!!!

Registered User
Quote:
Originally Posted by G35octane
so can i put dual intakes on a 2003.5???????????????/
you really upset me...

Registered User
Quote:
if you swap engines for the new VQ35HR then sure go ahead.DOMOOriginally Posted by G35octane
so can i put dual intakes on a 2003.5???????????????/
Registered User
I just finished installing the Stillen dual intake. Like UltimateGee27 already mentioned, the install was a breeze. I took it out for a little spin and this baby just screams in the higher rpms (4k +). Until you hit that point, you don't really notice it, but at WOT oh man, it's got some growl to it. I didn't notice any loss in power in the lower rpms, but I could definitley notice some extra kick when I hit past 4k rpms.
However, I had one little mishap. I accidentally dropped one of the bolts that secures the airbox into the little hood latch hole and it's just chillin inside the bumper. How would I get this out?
However, I had one little mishap. I accidentally dropped one of the bolts that secures the airbox into the little hood latch hole and it's just chillin inside the bumper. How would I get this out?
Registered User
Quote:
I think you can get them @ Home Depot or Ace HardwareOriginally Posted by Virus
Adjustable magnet rod. I've seen them around for car use, but I don't know where.
Registered User
Agreed. Mine looks like an Collapsible antenna from a portable radio. It has a magnet on the end of it.
I got my from Matco or one of those portable tool guys. Check them out if you don't have any luck at HD.
Kind of looks like this:
I got my from Matco or one of those portable tool guys. Check them out if you don't have any luck at HD.
Kind of looks like this:
Registered User
Same thing happen to me with a socket wrench attachment. I could not see where it fell also.
Engine compartment is so tight the only way I could get it out was driving around a curve (exit ramp).
Engine compartment is so tight the only way I could get it out was driving around a curve (exit ramp).

Registered User
Thanks for the clip! - I'm sold on the 07 with the Stillen exhaust and intake - I'm going to check out the July specials at the local dealership tomorrow. Damn that sounds SWEET!
Registered User
Quote:
hey gama, i saw ur postings in nicoclub!Originally Posted by gama
i think fujita is also good intake
u were just as curious as to how the stillen/fujita sounded as i am if not more!
did u install the fujita yet? please be sure to post the video clip here when u do =P
