obd2 port to be precise.

hey, as long as cobb does the same with this as they did for my 05--maintain the unique ID number on the ecu for smogging purposes, then it's all good.

 

Yeah I found the obd2 port, although the location is a bit retarded (had better accessto the port in my Audi), what do you mean by smogging purposes?

 

since 05, all ecu's have been required to hold a unique id number that smog joints can pull up to identify that the ecu belongs with the car. it's a bit like a fingerprint.

in the past, ecu flashes simply overwrote the current info. this wasn't a big deal. cobb's AP snapshots your factory programming, it seems, and retains the ID number that would have been overwritten by simpler/older flash methods. i get the feeling this is not a cobb-specific procedure.

 

Ah ok, makes a little bit more sense, and by flashing you guys mean re-mapping? chipping?

 

http://www.g35parts.com/9083/osc/pro...roducts_id=776

just came across that on g35parts.com. cobb tuning accessport for the 07+ 350z. isn't this what we have all been waiting for? or will this really only work on the 07 350z even though we have the same engine?...

 

MM intersting will it work on the X???

 

yes they do I have gone in once and will be working with Shawn Church and Cobb to get this going. Took one trip and now another this week probably to dl software and they will send it off. Hope to have this done and set by the VQ dyno day at S Church Auto.

 

Woooo-hooooo!!! I'm in as soon as it's ready!

 

You guys will be the first to know... Shawn is going working on accessport and Tein is taking measurement on my car this tues-thurs

I can't wait until both of these are done!

 

Sounds good, heard they were working on it, even better to hear that it's actually progressing....Just one question, would this be ok to use on a '08 Sedan? as The 07 and 08 aren't that much different? Or are we going to have to wait another year for a 08 equivalent?

 

i would assume it depends on the ecu trim(number/letters on the ecu cover)

 

Man I hope this works for 08's also I just ordered my HFC's and have a buddy that has a AWD dyno and tuning shop and yes they use Cobb.. Keeping my fingers crossed..

 

In as soon as it is ready too!

 

Looks like its ready to me..
http://www.cobbtuning.com/info/?id=4239

http://www.accessecu.com/accessport/nissan/350Z.html

Stage1 (+5.1% HP/+4.5% lb-ft.) & Stage2 (+8.5% HP/+9.8% lb-ft.) performance calibrations. Minimum of 91 octane fuel.
Stage2+ is intended for vehicles with cat-back exhaust, headers, plenum spacers, high flow catalysts or race pipes, and aftermarket intakes.

 

ya. ive been contacting cobb since oct of 07 so makes it over a year and each time they said they are working on it and will be out shortly. whatever that means.