Do Not buy hood locks from BAUSauto (carbodykits.com)
#1
BAUSauto Hood Lock Issue
Not sure where to put this thread.move if needed..
BAUSauto Hood Lock Issue
I got a set of these from BAUSauto and once i got a shop to install them, they began to rust. I contacted AeroCatch directly and this was their reply:
They sell the hood locks/latches as D1 Generation, Aero Catch, universal hood lock latches. These are all counterfeit as BAUSauto (carbodykits.com) is not a licensed AeroCatch dealer! I contacted BAUSauto and they said they would look into it and that was weeks ago. Please beware
BAUSauto Hood Lock Issue
I got a set of these from BAUSauto and once i got a shop to install them, they began to rust. I contacted AeroCatch directly and this was their reply:
Thank you for your email, unfortunately the catches in your pictures are counterfeit!! All our screws and pivot pins are made from stainless steel and the pivot pins are sonically welded in position whereas it is clear to see -in your pictures - that the handle pivot pin is coming out!! This needs to be addressed or the catches - you have- will lock up very soon!!
Please see our website page on counterfeit AeroCatch
; http//www.aerocatch.com/counterfeit-warning
Please see our website page on counterfeit AeroCatch
; http//www.aerocatch.com/counterfeit-warning
Last edited by blAk mAx; 07-03-2012 at 10:22 PM.
#2
#6
The following users liked this post:
tylerxfire (07-01-2012)
#7
Trending Topics
#12
Registered User
iTrader: (10)
this thread is ridiculous..this is a good company on this forum and im sure will make it right( well now i kinda hope they dont as the op went and jumped the gun and made a thread like this)..this thread should not have been made and the op should have just contacted eric and had it taken care of..
#14
this thread is ridiculous..this is a good company on this forum and im sure will make it right( well now i kinda hope they dont as the op went and jumped the gun and made a thread like this)..this thread should not have been made and the op should have just contacted eric and had it taken care of..