AZ: Dynojet results 07 6-MT 266whp, 233Tq
#1
AZ: Dynojet results 07 6-MT 266whp, 233Tq
My freind has a dyno at his shop that i'm doing my new subi project car. We were bored so we threw the G on the dyno, we ran it twice, I'll scan the dyno graph tomorrow, but the torque curve was the flatest i've seen since the new Z06 that dyno'd the other day.
It put 266 WHP and 233 Lb/ft of TQ at the rear wheels. Dynojet Dyno, Phx, AZ. car is bone stock, had it's firts oil change, and it has almost 6k miles on it.
AFR's looked a little rich, should be able to get some power out a tune for sure IMO.
It put 266 WHP and 233 Lb/ft of TQ at the rear wheels. Dynojet Dyno, Phx, AZ. car is bone stock, had it's firts oil change, and it has almost 6k miles on it.
AFR's looked a little rich, should be able to get some power out a tune for sure IMO.
#4
Joined: Feb 2006
Posts: 13,068
Likes: 101
From: Southern Cali --> 818
#7
That curve is absolutely astonishing. It's no wonder that the difference in spec sheet numbers between the VQ35DE and VQ35HR do not explain the rather large performance difference between the first and second generation models. I'm still...wow, that's amazing, especially for a naturally aspirated engine.
Trending Topics
#9
Those are nice numbers for a dynojet. Just looking at them without any overlays you can see how much nicer the power curve is on the newer HR motors. makes great mid range and top end power... doesn't fall off hardly at all after peak. I can't wait to see what these motors do with mods.
Were you having issues with the rpm pickups not working well at higher rpms or did you cut the runs short? Reason I ask is last time over at az dyno chip we had to reposition the rpm pickup to keep it from cutting out too.
Were you having issues with the rpm pickups not working well at higher rpms or did you cut the runs short? Reason I ask is last time over at az dyno chip we had to reposition the rpm pickup to keep it from cutting out too.
Thread
Thread Starter
Forum
Replies
Last Post
Thebaws11
G35 Coupe V35 2003 - 07
8
11-30-2016 12:54 PM