If the tire rubs or not will depend on the offset of your wheels, you have not stated the offset. I would say if your offset is less then 25 and you are planning on running a 285 you will most likely have to roll your fenders

 

That's definitely a valid point I considered. I can't find my receipt and have been lazy to pull my wheels off to check to see if its stamped on the backside. Most wheels are.

Another question I have for all who have rolled>> I looked at the fenders last night and it doesn't seem very difficult to roll them at all. My question is do you just roll the upper half seeing how the lower section of the wheel fender in the rear is "two parts" or do you do one continuous roll to both the upper and lower section of the fender. From my perspective last night with a flashlight it looks like only the upper section would probably "rub" the tire if its bigger.

How far did you roll your fenders? All that have rolled?

Thanks again! All have been very useful and informative!

 

You will just need to roll the top section