I got about 18k on my car and the tech who installed my rims told me my front pads are pretty worn and their eating the outside (or inside?) of the rotor. He recommened I change the rotors and pads. I was thinking just get it over with and get a full new set of rotors and pads for all 4 and was looking at this..

http://infinitipa.zoovy.com/c=3oSZ0q...duct/BREMBOKIT

Has anyone bought that and put it on their car? Or is their anything else out their that is better (and maybe even cheaper?) Thanks guys



Matt

I have Rotora Slotted Rotors & Project Mu B-Force Pads.

Best Pads I used so far.

I tried Stock (No duh!!!),Satisfied Ceremic, and Hawk HPS.

Out of all the pads I used, Project Mu B-force is superior. Especially when it comes to performance.

I bought a set of cross drilled and slotted for brembo for my car off of ebay. They were about 350.00 shipped, yes I said 350.00 shipped. They came in today, they look good but I havent installed them yet.

Well since Im pretty tight after buying my rims I decided to get a front set of Project MU-B Force pads and ill use my stock rotors (ill have the fronts resurfaced if really necessary). I suppose the rears are still fine, ill have them checked just incase. Thanks man

G352NV,

Was it the raceconcepts.net drilled/slotted rotors you bought? If not which company did you get them through? Thanks man


Matt

Thank you very much man!

No problem.

dang, 18k and your pads/rotors are already low? you must be having a lot of 'fun'
with your car. hehehe.

those rotors look goood.

well ...18k...isnt that bad, i had like 14k (kms instead of miles), and i had to change the rotors and pads already..even though it was covered by warranty