Pi-Thon Induction and Hose locks
#1
Pi-Thon Induction and Hose locks
Alright i have a few Pi-thon pieces for sale. The hose locks are $15 each shipped and the induction locks $195 shipped for all three. Good luck!
7/28/09 EDIT: 1 1a-o4 and 2 1a-08 left!
I have 2 1a-04 SOLD 1.
I have 2 1a-06 SOLD BOTH
I have 2 1a-08
I have 2 1a-09 SOLD BOTH.
And finally 3 induction locks for 3 inch intakes. SOLD
7/28/09 EDIT: 1 1a-o4 and 2 1a-08 left!
I have 2 1a-04 SOLD 1.
I have 2 1a-06 SOLD BOTH
I have 2 1a-08
I have 2 1a-09 SOLD BOTH.
And finally 3 induction locks for 3 inch intakes. SOLD
Last edited by Shrummi; 07-28-2009 at 09:54 PM.
#3
1/4 fit the radiator overflow. the 3/8 fit some of the vacuum hoses and the 1/2 fit over the stock heater hose. i'll link my bay. also where those thick blue hoses are those are 3/8's as well.
Last edited by Shrummi; 07-20-2009 at 10:24 PM.
#4
might be noob question.
will the intake locks make scratches on my intake pipe?
never used one so
Is the surface of these hose/intake locks suitable to be spray painted? will it stick?
I will pm you later today about the small locks. I need to take a look at my engine bay and decide which ones i will need.
i'll probably need all of them.
will the intake locks make scratches on my intake pipe?
never used one so
Is the surface of these hose/intake locks suitable to be spray painted? will it stick?
I will pm you later today about the small locks. I need to take a look at my engine bay and decide which ones i will need.
i'll probably need all of them.
#6
the intake ones go over your silicone couplers so it wont scratch the pipe the reason im selling those is my hks intake is too long as it is and these make it about 1/2 inch longer per induction lock so it wouldn't fit in my bay. wrenches are usually sold separately i have a set of each for myself but i can direct you to a website that has the wrenches in stock if you decide on buying my locks. induction locks i was able to tighten with a towel and my hands.
as for painting them i know there is at least one person on here painting them for their engine bay its basically just polished aluminum. should be fine.
as for painting them i know there is at least one person on here painting them for their engine bay its basically just polished aluminum. should be fine.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
THMotorsports
Suspension-Vendor
257
12-18-2018 05:43 PM
Hogbone
Engine, Drivetrain & Forced-Induction
2
09-28-2015 06:44 PM