Audio, Video & Electronics Post questions, reviews, and other general info about the G's Nav, sound system, or satellite radio

Double Din-ANSWER!!!

Thread Tools
 
Search this Thread
 
Rate Thread
 
  #62  
Old 04-06-2004, 03:27 PM
docron1's Avatar
Registered User
Join Date: Jan 2004
Location: Centerburg, Ohio (the geographical center of the Buckeye State)
Posts: 1,254
Likes: 0
Received 19 Likes on 4 Posts
Re: Double Din-ANSWER!!!

Yes, the stock ACC is integrated with the IC board that runs the radio, ac, cd changer controls. The Japan v35 ACC is a seperate piece to control the AC poperly since you will be getting rid of the stock IC board. The v35 ACC is not just buttons but an acutal AC controller. $220 is actually not that bad for an AC controller. IF you don't get the ACC, your AC will run heated or cold air to match 75 degrees, I think that is the default.

 
  #63  
Old 04-07-2004, 05:01 PM
nashg35's Avatar
Registered User
Join Date: Feb 2004
Posts: 38
Likes: 0
Received 0 Likes on 0 Posts
Re: Double Din-ANSWER!!!

Hey Joepaniolo:

VERY good job on the manual you put together for DIN conversion. I dropped my car off at the installer yesterday and went in today to check on the progress and make sure he took care of the Dual Climate Control!! He said the manual was damn good and helpful.... even though he said the whole process was a pain --- took 4 hours to get it all done but it looks good.. He also took digital pictures he's gonna e-mail me when I pick up the car tomorrow.


Quick question for everyone that's done this.. did any of you keep your audio steering wheel controls afterward? I figured to be using the remote or touch panel on my AVIC-N1 but wanted to see what route you all were going.

Later



 
  #64  
Old 04-08-2004, 05:00 AM
docron1's Avatar
Registered User
Join Date: Jan 2004
Location: Centerburg, Ohio (the geographical center of the Buckeye State)
Posts: 1,254
Likes: 0
Received 19 Likes on 4 Posts
Re: Double Din-ANSWER!!!

First of all, thanks. The guide is currently undergoing a revision with admin over at g-owners.com. It should be up in a couple days.

To retain the steering wheel controls, you have to get the PAC SWI-X. You splice into the steering wheel wiring that is for the radio controls, run an IR sensor wire up driver pillar A into the headliner and mount the IR sensor in the maplight so it points to the deck's IR sensor. It kinda funtions as a remote control.

The deck is so close to your right hand, you really don't need a remote control nor the PAC SWI-X for steering wheel controls.

docron1 aka joe

 
  #65  
Old 04-08-2004, 10:34 PM
nashg35's Avatar
Registered User
Join Date: Feb 2004
Posts: 38
Likes: 0
Received 0 Likes on 0 Posts
Re: Double Din-ANSWER!!!

Yeah Joe I know what you mean on the proximity to be able to touch the screen.. I just like having a remote to scroll through some of the options that I can memorize the key strokes without having to take my eyes off the road. The remote that they have right now isn't that great from what I've seen pictures of

 
  #66  
Old 04-09-2004, 10:35 AM
SuperCharged6MT's Avatar
Registered User
Join Date: Feb 2004
Location: Ft.Lauderdale, FL
Posts: 267
Likes: 0
Received 0 Likes on 0 Posts
Re: Double Din-ANSWER!!!

hate to keep this question going, but I am going to order my dash kit and i talked with Yosi but wanted to confirm everthing here before I order... I have a 2003 6MT Coupe w/o nav and black leather interior... Is this everything?

68260-AM913 Double din dash titanium
56.90USD
27500-AL501 AC controller
220.50USD
68470-35F00 Dash pocket
9.30USD
68470-60M00 Blank bracket
5.70USD
28038-710 nav/audio less
32.97USD

Just want a simple yay or nay... Thanks again guys, this forum is absolutely the best and I appreciate the help!!

 
  #67  
Old 04-09-2004, 05:07 PM
g35mt's Avatar
Registered User
Thread Starter
Join Date: May 2003
Posts: 913
Likes: 0
Received 0 Likes on 0 Posts
Re: Double Din-ANSWER!!!

That is what i order. I think it should be okay to also order the 28038-700 instead of the 28038-710. Either way, you should be okay. But i think you are better off with the 28038-700.

g35mt

 
  #68  
Old 04-09-2004, 05:50 PM
SuperCharged6MT's Avatar
Registered User
Join Date: Feb 2004
Location: Ft.Lauderdale, FL
Posts: 267
Likes: 0
Received 0 Likes on 0 Posts
Re: Double Din-ANSWER!!!

what is the difference between the two? Thanks man, I really appreciate the help!

 
  #69  
Old 04-09-2004, 05:53 PM
tgenius's Avatar
Charter Member Florida G35 Club
Join Date: Mar 2004
Location: Miami, FL
Posts: 1,216
Likes: 0
Received 0 Likes on 0 Posts
Re: Double Din-ANSWER!!!

Does anyone have the part # for the dash piece thats BLACK and not titanium?


2004 G35s 5AT DG/Graphite/Premium/Huper Optik Tint
 
  #70  
Old 04-09-2004, 06:40 PM
docron1's Avatar
Registered User
Join Date: Jan 2004
Location: Centerburg, Ohio (the geographical center of the Buckeye State)
Posts: 1,254
Likes: 0
Received 19 Likes on 4 Posts
Re: Double Din-ANSWER!!!

tgenius,

email J's Garage, they know what the black colored dash part number is.

i would go with the AL700 bracket too. I have premium withOUT navi and the AL700 worked fine.

 
  #71  
Old 04-10-2004, 03:48 AM
g35mt's Avatar
Registered User
Thread Starter
Join Date: May 2003
Posts: 913
Likes: 0
Received 0 Likes on 0 Posts
Re: Double Din-ANSWER!!!

if you look at the picture above the thread, u will noticed it. THe al700 look exactly like the original one on my car.

g35mt

 
  #72  
Old 04-10-2004, 08:55 AM
tgenius's Avatar
Charter Member Florida G35 Club
Join Date: Mar 2004
Location: Miami, FL
Posts: 1,216
Likes: 0
Received 0 Likes on 0 Posts
Re: Double Din-ANSWER!!!

I emailed J-Garage, and they say that the part for the black dash (instead of titanium) is: 68260-AL710 but that I had to verify it with someone? Who could verify that part # is in fact the black and not titanium dash?

2004 G35s 5AT DG/Graphite/Premium/Huper Optik Tint
 
  #73  
Old 04-10-2004, 03:31 PM
g35mt's Avatar
Registered User
Thread Starter
Join Date: May 2003
Posts: 913
Likes: 0
Received 0 Likes on 0 Posts
Re: Double Din-ANSWER!!!

please realize that i was refering to the metal bracket part number, not the dash part numbner.

g35mt

 
  #74  
Old 04-11-2004, 11:49 AM
JohnBoy's Avatar
Registered User
Join Date: Apr 2004
Location: Houston
Posts: 65
Likes: 0
Received 0 Likes on 0 Posts
Re: Double Din-ANSWER!!!

Did anyone ever figure out if there is a part # for the titanium dash with willow interior? It looks like the titanium one that everyone is getting has the black ends by the air vents which doesn't match the brown ends that the willow interior has.

Or I guess they could be painted brown. Does anyone know the paint code for the willow interior or know where to get a good match done for plastic auto parts?

 
  #75  
Old 04-11-2004, 06:26 PM
FluxG35's Avatar
Registered User
Join Date: Jul 2003
Location: CA/HI
Posts: 298
Likes: 0
Received 0 Likes on 0 Posts
Re: Double Din-ANSWER!!!

what's the website for J's garage? or any contact number? I want to order the double din....thanks!!

<font color=blue>*2004 DG 6-MT, Premium, Side Molding, Alum pedal sets, Aero Package, JWT Popcharger+Z-Tube, 19" Volk LE37T W/Toyo T1-S</font color=blue>
 


You have already rated this thread Rating: Thread Rating: 0 votes,  average.

Quick Reply: Double Din-ANSWER!!!



All times are GMT -4. The time now is 07:11 AM.