Hi all:

I need some clarification here:

2. Connect a 150 ohm resistor to pin 23(green). Connect a 47 ohm resistor to pin 22(red). Connect remaining ends of resistors to the INTERFACE's white wire. Connect pin 25(yellow) to chassis ground.

Does this mean both resistors are connected to the interface's white wire???

Is this normal???

 

Yes, both of the resistors connect to the white wire, like a Y. I added a short piece of wire to the other end of each resistor (the end not attached to the green or red wire) and connected both of those short ends to the white wire.

 

I'll do the same. Did you solder the resistor to the wire or other method?

 

Butt connectors.