Post pics of your double din setup
#467
how much do these Double din conversions approximately cost including installation? Did you guys buy all your parts online? thanks
just want to make sure, is this everything I need to get a double din conversion set? does the price look reasonable to you guys?
just want to make sure, is this everything I need to get a double din conversion set? does the price look reasonable to you guys?
![Post pics of your double din setup-nellx.png](https://g35driver.com/forums/attachments/audio-video-electronics/267171d1683070542t-post-pics-your-double-din-setup-nellx.png)
Last edited by van_driver; 06-22-2012 at 07:58 PM.
#468
#469
Depends on if you want to keep your steering wheel controls or add an aftermarket amp, subs, door speakers. Do you have a Bose system or factory navigation because that will determine what dash kit you need. Do you want a metra dash kit our an OEM dash kit. You still needed a double din trim ring to make it flush. Email me I can help you out the best I can I just did mine about 4 months back.
#470
Yes it is bose system without navigation.
This is the touch screen pioneer one with a rear camera as well
http://www.crutchfield.com/app/cart/...3&emKey=789563
and this is the one which is about half the price
http://www.crutchfield.com/app/cart/...3&emKey=789554
just a little confused as to which one would be more beneficial. I will probably get it installed as my technical skills are not good!
This is the touch screen pioneer one with a rear camera as well
http://www.crutchfield.com/app/cart/...3&emKey=789563
and this is the one which is about half the price
http://www.crutchfield.com/app/cart/...3&emKey=789554
just a little confused as to which one would be more beneficial. I will probably get it installed as my technical skills are not good!
#473
Factory Navigation Screen Housing Added To Non-Nav 2006
Here's the setup I installed a few years ago. I added the factory navigation screen housing and controls to a Non-Nav system using the the Electrical section of the Infiniti Service manual. My diagram of the wiring is included in the photos.
I removed the factory screen and installed an Alpine Touchscreen, which fits almost perfectly. As shown in the diagram, the operations of the navigation screen motor and the navigation switch illumination were restored by splicing into the A/C control wiring harness.
I wasn't able to find a Navigation version of the JDM Double Din Finisher at the time of installation, so the extra height of the non-Nav finisher required some modification that the installer wasn't able to get quite right.
I added switches on the side of the center console to control my front and rear license plate frame cameras. The upper switch turns the front bumper camera ON and OFF on the upper screen for more precise parking. The lower switch toggles the rear-view camera between ON and REVERSE on the lower screen as needed.
-Alpine IVA-W505 Double Din Head Unit
-Nissan 27500-AC500 A/C Control Module (DUAL button and LED soldered from original board)
-JDM Double Din Finisher
-Alpine TME-S370 Touchscreen Monitor with Alpine NVE-M300 Navigation
-Alpine KCA-SC100 Sirius Control Interface
-Sirius SC-C1 Sirius Controller
-Alpine PXA-H100 Imprint Module
-Alpine KCE-400BT Bluetooth Interface
-PAC SWI-JACK Steering Wheel Control Interface
http://photobucket.com/paclypse71
I removed the factory screen and installed an Alpine Touchscreen, which fits almost perfectly. As shown in the diagram, the operations of the navigation screen motor and the navigation switch illumination were restored by splicing into the A/C control wiring harness.
I wasn't able to find a Navigation version of the JDM Double Din Finisher at the time of installation, so the extra height of the non-Nav finisher required some modification that the installer wasn't able to get quite right.
I added switches on the side of the center console to control my front and rear license plate frame cameras. The upper switch turns the front bumper camera ON and OFF on the upper screen for more precise parking. The lower switch toggles the rear-view camera between ON and REVERSE on the lower screen as needed.
-Alpine IVA-W505 Double Din Head Unit
-Nissan 27500-AC500 A/C Control Module (DUAL button and LED soldered from original board)
-JDM Double Din Finisher
-Alpine TME-S370 Touchscreen Monitor with Alpine NVE-M300 Navigation
-Alpine KCA-SC100 Sirius Control Interface
-Sirius SC-C1 Sirius Controller
-Alpine PXA-H100 Imprint Module
-Alpine KCE-400BT Bluetooth Interface
-PAC SWI-JACK Steering Wheel Control Interface
http://photobucket.com/paclypse71
#474
Here's the setup I installed a few years ago. I added the factory navigation screen housing and controls to a Non-Nav system using the the Electrical section of the Infiniti Service manual. My diagram of the wiring is included in the photos.
I removed the factory screen and installed an Alpine Touchscreen, which fits almost perfectly. As shown in the diagram, the operations of the navigation screen motor and the navigation switch illumination were restored by splicing into the A/C control wiring harness.
I wasn't able to find a Navigation version of the JDM Double Din Finisher at the time of installation, so the extra height of the non-Nav finisher required some modification that the installer wasn't able to get quite right.
I added switches on the side of the center console to control my front and rear license plate frame cameras. The upper switch turns the front bumper camera ON and OFF on the upper screen for more precise parking. The lower switch toggles the rear-view camera between ON and REVERSE on the lower screen as needed.
-Alpine IVA-W505 Double Din Head Unit
-Nissan 27500-AC500 A/C Control Module (DUAL button and LED soldered from original board)
-JDM Double Din Finisher
-Alpine TME-S370 Touchscreen Monitor with Alpine NVE-M300 Navigation
-Alpine KCA-SC100 Sirius Control Interface
-Sirius SC-C1 Sirius Controller
-Alpine PXA-H100 Imprint Module
-Alpine KCE-400BT Bluetooth Interface
-PAC SWI-JACK Steering Wheel Control Interface
http://photobucket.com/paclypse71
I removed the factory screen and installed an Alpine Touchscreen, which fits almost perfectly. As shown in the diagram, the operations of the navigation screen motor and the navigation switch illumination were restored by splicing into the A/C control wiring harness.
I wasn't able to find a Navigation version of the JDM Double Din Finisher at the time of installation, so the extra height of the non-Nav finisher required some modification that the installer wasn't able to get quite right.
I added switches on the side of the center console to control my front and rear license plate frame cameras. The upper switch turns the front bumper camera ON and OFF on the upper screen for more precise parking. The lower switch toggles the rear-view camera between ON and REVERSE on the lower screen as needed.
-Alpine IVA-W505 Double Din Head Unit
-Nissan 27500-AC500 A/C Control Module (DUAL button and LED soldered from original board)
-JDM Double Din Finisher
-Alpine TME-S370 Touchscreen Monitor with Alpine NVE-M300 Navigation
-Alpine KCA-SC100 Sirius Control Interface
-Sirius SC-C1 Sirius Controller
-Alpine PXA-H100 Imprint Module
-Alpine KCE-400BT Bluetooth Interface
-PAC SWI-JACK Steering Wheel Control Interface
http://photobucket.com/paclypse71
my Bose stereo in my 04 isnt playing sound, thats it, so if i go with this DD alls i need is the PAC REOM NIS2, antenna adaptor and say the metra kit right?
#475
http://www.crutchfield.com/p_113DDX3...od-DDX319.html
my Bose stereo in my 04 isnt playing sound, thats it, so if i go with this DD alls i need is the PAC REOM NIS2, antenna adaptor and say the metra kit right?
my Bose stereo in my 04 isnt playing sound, thats it, so if i go with this DD alls i need is the PAC REOM NIS2, antenna adaptor and say the metra kit right?
#476
#479
Just watch this video. THere's like 3 seconds between every tap of the screen and the result:
Just look at it from 0:14 to 0:34. That's how long it takes them to get from playing one song by an artist to another.
Last edited by Wrathernaut; 08-16-2012 at 05:41 PM.
#480