Well, long story short, my dumbass installer knicked couple wires when he ran the speaker wires through the molex. So my windows up and the lock/windows control module Lighting is intermittent.

I found out it was the issue with the connection at the Molex connector because when I wiggle the wirelooms, the power comes off and on.

Therefore, does anyone have the pin out digram so I can check to make sure if these wires are the ones that cause the issue and not the others (while I have the door detached and the molex out?

Oh, and he went MIA as well as the shop went belly up so I have noone to go after

Thanks,





The bottom set of wires seem to be okay. The top 4 are brazed and the light blue wire is the one that being knicked the most with about half of its copper threads cut.

 

I'd cut the bad section out of that blue wire and make a more solid connection there.

Just fix the obviously damaged wires one at a time and you shouldn't have to worry about the pin-out.

 

Yea. I fixed the obvious blue wire but that didn't solve the problem. Just by wiggle the connector a lil, I'm loosing the power. Further troubleshooting shows that I'm loosing the 9V on a small red wire (at the controller).

I'll verify which red wire it is later. I don't know if it's the only one that's intermittent or there's more. For all I know, the 9V may be powering the entire module (button LEDs, under door lights, and windows up/down enable. If that's true, then it's an easy fix.

We will see. More feedback later. Also, any suggestion is welcomed.

Thanks,