new battery in the trunk
#18
sorry for the way way late response guys, completetly forgot about this thread, and im always on g35nyc
I always actually thinking about this
https://www.dcpowerinc.com/fit/2005~...51-270-xp.html
might as well go hard
well whenever i do raise up the volume real loud, i drop the back seat to let the air flor from outside, i havent had anyproblems with it getting hot, only once when i was parked up and listening to music for about 1.5 hrs did it go into protect mode......i really want to upgrade the alternator but right now i dont have the funds with child support and all lol...modding the G very slowly
I still havent re done the sub woofer box, its been pounding real hard, all summer long with no issues......i do however wanna upgrade my current 6.5 inch 02 front door speakers to 8inch beyman, my car audio guy found a way to make them fit with the stock door panel, oem bose location, audio sleeper lol
https://www.dcpowerinc.com/fit/2005~...51-270-xp.html
might as well go hard
I still havent re done the sub woofer box, its been pounding real hard, all summer long with no issues......i do however wanna upgrade my current 6.5 inch 02 front door speakers to 8inch beyman, my car audio guy found a way to make them fit with the stock door panel, oem bose location, audio sleeper lol
Last edited by racercris15; 08-09-2012 at 12:48 PM.
#24
so after re coning the sub and then it blowing out again after a month lol, i bought used BTL n2 for now until the new re cone kit comes for my original sub (takes about a month or two to be built).... also lowerd the bass from the amp to make sure i dont blow this out out
going with 2 12inch BTL's in the trunk for the spring, should be ordering the DC power high output alternator within the next week or so
going with 2 12inch BTL's in the trunk for the spring, should be ordering the DC power high output alternator within the next week or so
#26
#27
#29
#30
1. Where's your LPF set at? What slope?
2. What's your HU, and what are the preamps rated at? (don't know your system)
2a. How high is the non fading (sub) preamp level set at?
2b. Are you using bass boost from the HU, or any loudness-type feats?
2c. Using a test tone, how high can you go on the volume scale before the signal clips? (i.e. did you remain under unclipped HU power)
3. What's the amp gain/sensitivity scale i.e. lowest & highest voltage levels taken in?
4. Did you build your ported enclosure within the parameters set by Fi? What's the tuning freq of the port?
If you have a hard time answering any of those questions, and considering you're running a 200+ amp system without a HO alt, don't be surprised you're having issues - sorry.