Interior wiring to match ignition
#1
Interior wiring to match ignition
I'm wiring a small dash cam and I don't want wires everywhere, I have the FSM but it doesn't show how to pull off the front panels or where the screws and clips are so I don't want to ruin anything by yanking it right off.
Is there any well known 12v source that's only hot when the ignition is on, and off when the car is off? Ideally I'd like to tap into the cigarette lighter, but this is going to be on the far left corner, just above the left AC/heater vents so that's a little far.
Any advice would be great!
Is there any well known 12v source that's only hot when the ignition is on, and off when the car is off? Ideally I'd like to tap into the cigarette lighter, but this is going to be on the far left corner, just above the left AC/heater vents so that's a little far.
Any advice would be great!
#3
#4
The following users liked this post:
adamj27 (09-06-2012)
#5
Edit: Just kidding. Everything went well until I plugged the camera in and didn't notice its a 5v input. Fried the internals, waiting on ebay for a 12v camera from china again, it'll be a few weeks.
Last edited by adamj27; 09-06-2012 at 09:54 PM.
Thread
Thread Starter
Forum
Replies
Last Post
AuAltima3.5
Audio/Video/Electronics
4
09-13-2015 11:48 AM