This is more simple than u think..

STEP 1!!!!!
Turn your wheel or REMOVE your wheel (i removed for picture purposes) for more clearance to do this job. then jack it up


STEP 2!!!!!!
Use a flat head screwdriver to remove 4 clips. Then just kinda tug out the fender liner and pull back. shown here:


STEP 3!!!!!
Remove Cap. Use ur fingers and push the two wires together, push forward a little bit, squeeze a little bit, then pull back then u release the hid.


STEP 4!!!!
By now u should know what to do.. if not.. just twist the base of the lightbulb to loosen it and remove.. replace.. and just go backwards.. (securing the wires back is a little tricky but you'll get it with some patience)

I actually did this all by myself w/o instructions.. i stood outside looking at my car and just did it... but its over with.. i'll post a pic of my car with the installed 8000k bulbs when it gets darker..

GOOD LUCK!~!!

 

Could I change the ballast this way also?

 

You should have enough clearance if you take the wheel & liner off to replace the ballast..

 

possible to do it without taking wheel off and just turning wheels in?